Replace the rechargeable handset battery pack | Uniden WXI377

•If there is any foreign matter on the rubber seal located on the under side of the battery cover, the handset may not be water resistant.

•The rubber seal should be kept clean and replaced every 2 years to ensure the handset is water resistant even if the seal does not look worn.

Do not place a wet or dirty handset in

the base.

Replace the rechargeable handset battery pack

1)Remove the 3 screws holding the battery compartment with a screwdriver and take off the battery cover. Remove the old battery pack in the battery compartment.

2)Plug the replacement battery connector (red & black wires) into the small, black jack inside the battery compartment. (The connector notches fit into the grooves of the jack only one-way.) Match the wire colors to the polarity label in the battery compartment, connect the battery and listen for a click to insure connection.

3)Make certain you have made a good connection by slightly pulling on the battery wires. If the battery connector is not securely connected, the handset will not charge properly.

4)Before placing the battery cover back on the handset, make sure there is no foreign matter under the rubber seal located on the under side. By inserting bottom first, place the battery cover back on the handset and tighten the 3 screws.

Rubber Seal

[ 10 ] G E T T I N G S TA R T E D

www.uniden.com

Image 10

Uniden WXI377 manual Replace the rechargeable handset battery pack

Contents

Page Page Handset Base unitTelephone cord Contents Features Welcome Controls and Functions N T R O L S a N D F U N C T I O N S Do the following steps Setting up the PhoneChoose the best location Avoid microwave ovens Activate the handset before charging the battery Getting Started Replace the rechargeable handset battery pack Talk Mode Battery use time per chargeLow battery alert Standby Mode Connect the base unit AC adapter Mounting the Base Unit on a Wall Standard wall plate mounting Direct wall mounting Setting Menu Options Caller ID options Entering Your Area Code Choosing the dialing mode Setting the language Making and Receiving Calls Handset On Base Handset Off Base Earpiece volume Adjusting the Handset Ringer and Earpiece VolumeHandset ringer tone and volume Redial Tone Dialing Switch-over Traveling Out-of-Range Selecting a Different Channel Flash and Call Waiting Storing Phone Numbers and Names Memory Dialing E M O R Y D I a L I N G Steps for Entering Names and Special Characters If you make a mistake while entering a name Memory dialing from Talk Mode Memory dialing from Standby ModeMaking Calls with Memory Dialing Chain Dialing Editing a Stored Name and/or Phone Number Cursor flashes indicating that the display is ready for Erasing a Stored Name and Phone Number Press select or delete/ch Storing and Editing the RocketDial RocketDialMaking Calls with the RocketDial Deleting the RocketDial C K E T D I a L You must subscribe to Caller ID service to use this feature When the Telephone RingsCaller ID Viewing the Caller ID Message List Press cid/menu Deleting Information from the Caller ID List When the pointer is at YesWhen the pointer is at No Deleting a Caller ID message Long Distance calls and Area Code Setting/Cancellation Using the Caller ID ListCalling a party from the Caller ID list Storing Caller ID messages in Memory dialing To attach the beltclip Installing the BeltclipChanging the Digital Security Code To remove the beltclip Power Failure MaintenanceBattery replacement and handling When the handset or base unit becomes slightly dirty Troubleshooting Symptom Suggestion Charge/in use LED wont Symptom Suggestion Liquid Damage Case Action General Information Battery InformationAC Adapter Information Important Safety Instructions PrecautionsImportant Electrical Considerations Installation Considerations One Year Limited Warranty Terminal Equipment Radio Equipment G, H At Uniden, we´ll take care of you