Choosing the dialing mode | Uniden WXI377 specification

Choosing the dialing mode

Most phone systems use tone dialing which sends DTMF tones through the phone lines. However some phone systems such as in rural areas still use pulse dialing. The default setting is tone dialing. Depending on your dialing system, set the mode as follows:

1) When the phone is in the standby mode, press and hold cid/menu. The following screen appears.

2) Press 4 or the vol/- key three times to select “Dial”.

3) Press select to toggle between “Tone” and “Pulse” for each setting.

4)Press end or return the handset to the base unit to complete the setting. The handset returns to the standby mode.

•If you are not sure of your dialing system, set for tone dialing. Make a trial call. If the call connects, leave the setting as is, otherwise set for pulse dialing.

•If your phone system requires pulse dialing and you need to send the DTMF tones for certain situations during a call, you may “switch-over” to tone dialing. (Refer to

“Tone Dialing Switch-over” on page 21.)

Make sure your battery pack is fully charged before choosing the dialing mode.

GETTING STARTED

www.uniden.com

G E T T I N G S TA R T E D [ 17 ]

Image 17

Uniden WXI377 manual Choosing the dialing mode

Contents

Page Page Telephone cord Base unitHandset Contents Welcome Features Controls and Functions N T R O L S a N D F U N C T I O N S Choose the best location Setting up the PhoneDo the following steps Avoid microwave ovens Getting Started Activate the handset before charging the battery Replace the rechargeable handset battery pack Low battery alert Battery use time per chargeTalk Mode Standby Mode AC adapter Connect the base unit Standard wall plate mounting Mounting the Base Unit on a Wall Direct wall mounting Caller ID options Setting Menu Options Entering Your Area Code Choosing the dialing mode Setting the language Handset On Base Handset Off Base Making and Receiving Calls Handset ringer tone and volume Adjusting the Handset Ringer and Earpiece VolumeEarpiece volume Redial Traveling Out-of-Range Tone Dialing Switch-over Flash and Call Waiting Selecting a Different Channel Memory Dialing Storing Phone Numbers and Names E M O R Y D I a L I N G If you make a mistake while entering a name Steps for Entering Names and Special Characters Making Calls with Memory Dialing Memory dialing from Standby ModeMemory dialing from Talk Mode Editing a Stored Name and/or Phone Number Chain Dialing Cursor flashes indicating that the display is ready for Press select or delete/ch Erasing a Stored Name and Phone Number Making Calls with the RocketDial RocketDialStoring and Editing the RocketDial C K E T D I a L Deleting the RocketDial Caller ID When the Telephone RingsYou must subscribe to Caller ID service to use this feature Press cid/menu Viewing the Caller ID Message List When the pointer is at No When the pointer is at YesDeleting Information from the Caller ID List Deleting a Caller ID message Calling a party from the Caller ID list Using the Caller ID ListLong Distance calls and Area Code Setting/Cancellation Storing Caller ID messages in Memory dialing Changing the Digital Security Code Installing the BeltclipTo attach the beltclip To remove the beltclip Battery replacement and handling MaintenancePower Failure When the handset or base unit becomes slightly dirty Symptom Suggestion Charge/in use LED wont Troubleshooting Symptom Suggestion Case Action Liquid Damage AC Adapter Information Battery InformationGeneral Information Important Electrical Considerations PrecautionsImportant Safety Instructions One Year Limited Warranty Installation Considerations Terminal Equipment Radio Equipment G, H At Uniden, we´ll take care of you