Unisen 265 Series, 154 Series NetCommand Control of a Device Con- nected to an HDMI A/V Receiver

6. NetCommand Control of an A/V Receiver (265 Series) 71

Setting Up A/V Receiver Control, continued

NetCommand Control of a Device Con- nected to an HDMI A/V Receiver

Use this setup to have NetCommand control a device sending audio and video through the A/V receiver to the TV via HDMI.

You must have already completed the procedure under “Setup to Control Automatic Audio and Video Switch- ing via HDMI” on the opposite page. That procedure placed an icon in the Input Selection menu for the device (input) connected to the A/V receiver.

Any Connection		HDMI
Type		Cable
Source	A/V	TV
Device	Receiver

1.Set up NetCommand control of A/V receiver audio/ video switching via HDMI as described on the opposite page.

2.Press EXIT to close any open menus and return to normal TV viewing.

3.Press INPUT.

4.Highlight the icon for the A/V receiver input you wish to control.

5.Press ENTER to switch the TV to the A/V receiver and the A/V receiver to the input.

6.Open the Inputs > Learn menu.

7.Perform NetCommand “learning” for the con- nected )device by following the steps in “Initial NetCommand Setup,” page 62.

Downloaded From TV-Manual.com Manuals

For assistance call 1(800) 332-2119