Universal Electronics DVR/PVR 5-Device, M11055BS manual Programming ID Lock

PROGRAMMING ID LOCK

The Atlas DVR/PVR 5-Device Universal Remote Control with Learning is locked at the factory to operate a Scientific Atlanta cable converter. However, if you have another brand or model of cable converter or satellite service that you would like to control, then you’ll need to perform the following steps to unlock the ID Lock, enter a new manufacturer’s code, and lock the ID Lock again.

1.Turn on the cable converter.

2.On the remote control, press CBL once; it will blink once. Then press and hold SETUP until the CBL key blinks twice.

3.Enter 9 8 2. The CBL key will blink four times, indicating ID Lock is unlocked.

4.Perform the instructions under “Programming Device Control” on page 8 to program device control for the desired cable converter or satellite receiver.

When you are done, perform steps 5 and 6 on this page to again lock the ID Lock.

5.On the remote control, press CBL once; it will blink once. Then press and hold SETUP until the CBL key blinks twice.

6.Enter 9 8 2. The CBL key will blink twice, indicating ID Lock is again locked.

PROGRAMMING TUNE-IN

KEYS FOR SPECIFIC CHANNELS

The Atlas DVR/PVR 5-Device Universal Remote Control with Learning includes three Tune-In keys (located directly below the MUTE and LAST keys). Each can be programmed to remember five of your favorite cable channel settings for a total of fifteen channels. If you want to change the cable channels in a previously- programmed Tune-In key, you’ll need to clear the key first (see “Clearing a Tune-In Key” on page 19).

www.urcsupport.com

18