NOTE: Only one device can be assigned to an unused device key at a time.

To Re-Assign

Perform Key Sequence

 

 

AUX as 2nd

AUX￿SETUP￿9￿9￿2￿AUD￿AUX

AUD key

 

 

 

AUX as 2nd

AUX￿SETUP￿9￿9￿2￿TV￿AUX

TV key

 

 

 

AUX as 2nd

AUX￿SETUP￿9￿9￿2￿CBL￿AUX

CBL key

 

 

 

AUX back to

AUX￿SETUP￿9￿9￿2￿AUX￿AUX

AUX

 

 

 

To re-assign another unused device key, substitute it for the AUX key above and then perform the sequence. For example, to re-assign an unused AUD key as a second DVD key, perform AUD￿SETUP￿9￿9￿￿DVD￿AUD.

When a re-assignment is done, the selected device key (e.g., AUD) will blink twice to confirm your choice. At that time, you will need to program device control (see “Programming Device Control” on page 8).

CLEARING CUSTOM PROGRAMMING

The Atlas DVR/PVR 5-Device Universal Remote Control with Learning contains a Custom Programming Reset program. You can use it to remove all custom programming, except your setup codes and reassigned device keys.

IMPORTANT: Executing this program will erase all cus- tom settings for Volume Lock, Learned Keys, Tune-In Keys, and Channel Lock. However, your device programming remains.

1.On the remote control, press and hold SETUP until the last-selected device key blinks twice.

2.Enter 9 8 0. The last-selected device key

blinks twice, pauses, and blinks twice again to confirm that all custom programming is cleared.

TROUBLESHOOTING

PROBLEM: Device key does not blink when you press a key.

SOLUTION: Replace the batteries with two (2) new AA alkaline batteries (see “Installing Batteries” on page 8).

www.urcsupport.com

22

Page 22
Image 22
Universal Electronics M11055BS, DVR/PVR 5-Device manual Clearing Custom Programming, Troubleshooting