Universal Electronics M11055BS manual Programming a Tune-In Key, Clearing a Tune-In Key

Programming a Tune-In Key

1.On the remote control, press CBL once; it will blink once. Then press and hold SETUP until the CBL key blinks twice.

2.Enter 9 9 5. The CBL key will blink twice.

3.Select a Tune-In key and press it once.

4.Press CBL once, followed by the channel number to be programmed (e.g., 3 9 for channel 39).

NOTE: If you are programming a channel for a Digital Cable Converter, you need to enter all channels in a 3-digit channel format. For example, to program channel is 39, enter

0 3 9.

5.Press and hold SETUP until the CBL key blinks twice.

6.To add another channel, repeat steps 1 through 5, substituting the new channel to be added in step 4.

NOTE: Programming more than five channels on the same Tune-In key will overwrite previous settings.

Clearing a Tune-In Key

1.On the remote control, press CBL once; it will blink once. Then press and hold SETUP until the CBL key blinks twice.

2.Enter 9 9 5. The CBL key will blink twice.

3.Press the Tune-In key you want to clear once.

4.Press and hold SETUP until the CBL key blinks twice.

This Tune-In key is now clear and ready for reprogramming (see “Programming a Tune-In Key” on page 19). If desired, repeat these to clear another Tune- In key.

www.urcsupport.com

19