Generic Pioneer Charter OCAP.fm Page 12 Friday, July 20, 2007 1:28 PM

1.For a TV/DVD Combo, turn on your TV/DVD Combo and insert a DVD. (For a TV/VCR Combo, insert a videocassette).

2.On the remote control, press DVD once; it blinks once. Then press and hold SET UP until

the DVD key blinks twice.

3.Use the “Manufacturer’s Codes” starting on page 24 to locate the brand name and enter the first five-digit code for your combo device (for example, TV/VCR). If you perform this procedure correctly, the DVD key blinks twice.

NOTE: If the DVD key did not blink twice after enter- ing the codes last digit, repeat steps 2 through 3 and try entering the same code again.

If you’ve located a setup code that works for your combo device (for example, a TV/DVD Combo) and a separate TV code is also listed, you’ll need to program this code into the remote control to access volume control (see “Programming Device Control” starting on page 10).

4.Aim the remote control at your combo device (for example, TV/DVD Combo) and press

PWR once. The device should turn off. If it does not respond, repeat steps 2 through 3, trying each code listed for your brand until you find one that works. If it still does not respond, try searching for the code (“Searching for Your Code” starting on page 12).

5.For future reference, write down each working device code in the boxes below:

TV/VCR or TV/DVD Code

TV Code (if used)

SEARCHING FOR YOUR CODE

If your home entertainment device does not respond to the C4000 and S4000 Remote Controls after trying all of the codes listed for your brand, or if your brand is not listed at all, try searching for your code.

www.urcsupport.com

12

Page 12
Image 12
Universal Electronics S4000, C4000 manual Searching for Your Code, DVD key blinks twice