Universal Remote Control URC-100 owner manual Basic Setup, Pre-Programmed Method

U R C - 1 0 0

Basic Setup

You can start setting up your Unifier using either the Pre-Programmed Method or the Learning Method. However, all the buttons of the Unifier are setup at once with the Pre-Programmed Method, so it is usually faster than the one-button-at-a-time Learning Method.

Pre-Programmed Method

1	Power on the A/V component you wish to setup, so that
	you can test codes by sending power off commands.

Refer to the pre-programmed code tables on pages

2 25 - 46 and write down the code numbers listed for your A/V component. The code numbers are listed by categories of devices, then by brand. See page 25 for a category list.

3	Press and hold both the SHIFT and ENT (Enter)
	buttons for approximately three seconds. The top of

the display will blink “SET” then one of the eight device names. You are in SETUP mode now.

Note: You have 30 seconds to perform a step while you are in SETUP mode. If you don’t press a button within that time, the Unifier will time out and return to normal operation.

SHIFT

ButtonENT

Button

5