| T h e U n i f i e r |
|
|
4 | Choose the name of the device you’d like to |
| setup. Use the cursor LEFT or RIGHT buttons to |
change the flashing name.
For Example: I wanted to setup the TV Device button first, so I pressed the cursor LEFT or RIGHT until “TV” was flashing on the display.
LEFT | RIGHT |
|
5 | Point the Unifier at the component, then enter the |
| first three digit code number from your notes using |
the numbered buttons. After you enter each three digit code number, look at the component to see if it turned off.
Using the numbered buttons, enter the
3 digit code
number.
Continue to enter code numbers until the component powers off.
For Example: I have a Sony TV. I found the code numbers 070, 139,147, 126, 185, 194 and 085 under Sony in the TV TABLE. Using the numbered buttons on the Unifier, I entered 070 and looked at the TV. It didn’t turn off, so I entered 139, then 147 and so on, until I found the code that powered off the TV.
6
