U R C - 1 0 0
Advanced Setup
After you’ve finished all your basic setup, you can choose to make operation easier by customizing the Unifier just the way you want, using the Advanced Setup features described in this section.
Own Two VCR’s?
Set Aux to be VCR2
Any device button can be setup for ANY type of component (for example, you can make the AUX device button operate a second VCR). To setup a device button for a different type of component, use these steps:
1 | Power on the A/V component you wish to setup, so that |
you can test codes by sending power off commands. |
Refer to the
2 25 - 46 and write down the code numbers listed for your A/V component.
Press and hold both the SHIFT and ENT (Enter)
3 buttons for approximately three seconds. The top of the display will blink “SET” for a moment.
SHIFT | ENT |
Button | Button |
Note: You have 30 seconds for each step, otherwise the Unifier will time out automatically.
13
