U R C - 3 0 0

10When the display shows “MAIN”, you are back in normal operating mode. Now it’s time to test all the buttons. If some buttons don’t work, try repeating steps 1-9, to see if you can improve the match to your component.

For Example: My Sony TV powered off with TV code number 139. However the number buttons didn’t work when I tested them. So, I repeated steps one to ten, using other code numbers and eventually discovered that when code number 185 is set, all the buttons work perfectly.

11Repeat steps one through nine for each of your devices. In most systems, you can finish basic setup in just a few minutes and put all your old remote controls away.

If you are still missing commands to control any of your devices, use the Learning Method on the next page.

9

Page 11
Image 11
Universal Remote Control URC-300 owner manual C 3 0