COMBUSTION AIR / VENTILATION
The POWERMAXtm must be provided with an adequate supply of air for proper combustion and ventilation as required by the National Fuel Gas Code, ANSI Z 223.1 or any local codes that supercede the National Code. Do not obstruct the combustion and/or ventilation air supply openings.
CAUTION: Combustion air must not be contaminated by corrosive vapors or fumes, i.e. salt, chlorine, refrigerant gases, detergents, paints, cleaners, etc.. Any damage caused by insufficient or contaminated combustion air or improper venting will not be covered under the warranty.
EXHAUST VENTING
The POWERMAXtm Booster Heater is classified as a category IV appliance (positive flue pressure, flue gas temperature of approximately 190 degrees Fahrenheit, possible condensate). Vent piping must be one of the types detailed in this manual or a factory approved (in writing) alternate and must be installed according to the vent pipe manufacturers instructions. All joints must be properly sealed and secured to maintain joint integrity. All vent piping must slope toward the appliance a minimum of 1/4 inch per foot of length. The National Fuel Gas Code, ANSI Z223.1 requires that the booster heater be vented in one of the following three ways:
1.Into the dishwasher exhaust system. (See fig.1). The vent pipe must not penetrate any grease filter, but should terminate within the hood “capture zone”. In cases of a “pantleg” type of vent (see fig. 2), the vent pipe may terminate below an approved ‘eyebrow’ penetration of the duct. When vented into the dishwasher exhaust system, an electrical interlock must be provided (by others) to prevent the appliance from firing if the exhaust system is not providing sufficient draft for any reason.
3
