INSTALLATION
Continued
9.If blower is installed, route blower electrical cord through access holes in either side of fireplace. Note: Bushing may be moved if necessary. Plug electrical cord into electrical outlet.
10.Carefully insert fireplace into cabinet mantel (Figure 12). Be careful not to scratch or damage hearth base, cabinet mantel, or any laminate trim on hearth base. Remove pro- tective material from top of hearth base and from front of fireplace (if any). Note: You can secure fireplace to hearth or floor. Open lower louver. Locate screw holes in bottom of base. Tighten wood screws through these holes and into hearth or floor.
11.Attach gas line from fireplace gas regulator to gas supply. See Connecting Fireplace to Gas Supply, page 14.
12.Check all gas connections for leaks. See Checking Gas Connections, page 15.
Cabinet
Mantel
Figure 12 - Inserting Fireplace Into Cabinet Mantel
BUILT-IN FIREPLACE INSTALLATION
12.Follow the instructions below to install the fireplace in this manner.
Height | Actual | Framing | ||||||
32 | 3 | /8" | 33" | |||||
Front Width | 34 |
| 5 | /16" | 35 | 1 | /2" | |
Depth | 16 | 11 | /16" | 17 | 3 | /4" | ||
1.Frame in rough opening. Use dimensions shown in Figure 13 for the rough opening.
If installing in a corner, use dimensions shown in Figure 14 for the rough opening. The height is 33" which is the same as the wall opening above.
Figure 10 - Installing Cabinet Mantel
Nailing
Flanges
Figure 11 - Location of Nailing Flanges
| 17 3/4" |
33" |
|
35 | /2" |
| 1 |
Figure 13 - Rough Opening for Installing | |
in Wall | |
393/8"
|
| 27 | 7 | /8" |
35 | 1 | /2" |
|
|
55 | 5 | /8" |
|
|
Figure 14 - Rough Opening for Installing | ||||
in Corner |
|
| ||
www.desatech.com | 11 |
