Defiant 1610
48"
(1220 mm)
48"
(1220 mm)
Refer to
48" IMPORTANT 
(1220 mm) Note on This 
Page
48"
(1220 mm)
ST497
48"
(1220 mm)
48"
(1220 mm)
|
| Refer to |
48" | IMPORTANT | |
(1220 mm) | Note on This | |
| ||
|
| Page |
|
| |
|
|
|
| 48" | |
| (1220 mm) | |
ST499
Fig. 16 Parallel installation, vertical chimney connector, two wall shields. Reduced clearances for both rear and side walls. Wall shields may meet at corner if desired. Shielding for con- nector is centered behind connector.
Fig. 18 Corner installation, vertical chimney connector, two wall shields. Reduced side clearances. Wall shield MUST meet at corner.
IMPORTANT: when the stove is installed with 8” con- nector pipe, wall shields must extend to within 1” (25
48"
(1220 mm)
48"
(1220 mm)
Refer to
IMPORTANT Note on This Page
48"
(1220 mm)
ST498
mm)of the ceiling (up to 9’ (2.7 m)) due to potentially higher pipe temperatures. With 6” connections, the wall shields only need to extend to a height of 48” (1220
mm)as shown in the grey shaded areas of Figures 16, 17 and 18.
Fig. 17 Parallel installation with rear wall pass-through, two wall shields. Reduced clearances to both rear and side walls. Wall shields may meet at corner if desired. Wall pass-through must comply with codes.
Refer to “Special Installations.”
30002850 | 17 |
