Install the Optional Ash Door Heat Shield

Many installations will require the use of the supplied ash door heat shield. Refer to the “Floor Protection” sections starting on Page 10 to determine if your instal- lation requires the use of the ash door heat shield.

1.Remove the two Phillips pan head screws from the ash door.

2.Insert the screws through the ash door heat shield (from the painted side), place the 5/16” spacers over the screws, and carefully thread them back into the original holes. (Fig. 23) The curved lip should be upward, under the ashlip of the stove.

3.Tighten securely.

Spacers

ST538

Fig. 23 Install the ashdoor heat shield.

Adjust the Leg Levellers

Lift the stove slightly so there is no weight on the leg while making the adjustment.

Reverse the Flue Collar (If necessary)

Reverse the flue collar by removing the two screws that attach it to the back of the stove. Be sure the gasket around the flue collar opening is in position when you screw the collar back onto the stove.

Defiant 1610 Non-Catalytic Woodburning Stove

Attach the Damper Handle

Use the 1/4” -20 x 3” screw to attach the damper handle to the damper stub on the left side.

Attach the Primary Air Thermostat Handle

The primary air thermostat handle is the smaller of the two black handles. Secure the handle to the stub on the right side of the stove with an 8-32 x 2” slot head machine screw. (Fig. 24)

Assemble the Removable Insert Handle

The ceramic removable insert handle opens and closes the front doors. Remove after each use, and store it in the handle holder behind the right front leg. Assemble the handle by passing the 3³⁄₈" screw through the ceramic shaft and into the bright metal nub. (Fig. 25) Tighten carefully until snug.

ST539

Fig. 24 Attach the thermostat handle.

ST540

Fig. 25 Assemble the front door handle.

30002850

21

Page 21
Image 21
Vermont Casting 1610 Install the Optional Ash Door Heat Shield, Adjust the Leg Levellers, Attach the Damper Handle