Vermont Casting 2465, 2466 manual Operation, Your First Fire, Pilot and Burner Inspection, 30001935

Dutchwest Direct Vent / Natural Vent Gas Heater

Operation

Your First Fire

Read these instructions carefully and familiarize your- self with the burner controls. Locate the pilot assembly, Figure 45. Follow the lighting instructions on Page 25 exactly.

During the first fire, it is not unusual to smell some odor associated with new logs, paint and metal being heated. Odors should dissipate within an hour or so, however, you can open a window to provide fresh air to alleviate the condition.

Pilot and Burner Inspection

Each time you light your heater check that the pilot flame and burner flame patterns are as shown in Figure

47.If flame patterns are incorrect, turn the heater off. Contact your dealer or a qualified gas technician for as- sistance. Do not operate the heater until the pilot flame is correct.

Follow regular maintenance procedures as described on Page 30.

Pilot Assembly ST769

Fig. 45 Pilot assembly location.

Flame & Temperature Adjustment

For stoves equipped with HI/LO valves, flame adjust- ment is accomplished by rotating the HI/LO adjustment knob located near the center of the gas control valve. (Fig. 46)

Turn
counterclockwise	��	��	Turn clockwise
to decrease			to increase
flame height			flame height

Fig. 46 Flame adjustment knob for Honeywell valve.

Flame Characteristics

It is important to periodically perform a visual check of the pilot and the burner flames. Compare them to Figure 47. If any of the flames appear abnormal, call a service person.

	CO106c
Red
Glow
	LG143
Fig. 47	Correct pilot and burner flame patterns.

30001935 23