Vermont Castings Pinnacle & Stardance Direct Vent - Rear Vent Gas Heaters
Switch
AssemblyExisting
Holes
Screws |
ST315 |
Fig. 47 Attach switch assembly to rear shroud. |
TH |
TP |
TPTH |
PILOT ADJ |
ST228 |
Fig. 48 Attach switch wires to valve.
Install the Front and Top Plates
The Stardance stove shell is available with either a solid front plate or an operable door front plate. The front plates are installed in the same manner.
1.Grasp the Front Plate and lift it into position, engag- ing the two steel tabs at the upper corners behind the adjacent bosses in the Side Plates. (Fig. 49) Seat the Front against the Sides so that the tabs at the bottom lip engage with the notches in the edge of the stove base.
When properly installed, the bottom of the Front Plate cannot be pulled away from the sides without also lifting it up.
Bottom Tabs |
|
Engage Notch in Base | ST407 |
Fig. 49 Install Stove Front.
2.If you are installing optional Warming Shelves, do so now, according to the instructions supplied with that kit.
3.Install the Top Plate. The upper edges of the side plates should seat into the channel on the underside of the Top. (Fig. 50)
ST475a
Fig. 50 Install top plate.
Thermostat Connection
(Optional) R Models Only
Use only a thermostat rated for 500 - 750 millivolts.
Check the table below for the appropriate gauge thermostat wire to use for the length of lead required in your installation.
Thermostat |
|
Wire / Gauge | Maximum Run |
18 | 40 feet |
20 | 25 feet |
22 | 16 feet |
1.Install the wall thermostat in the desired location and run the wires to the stove location. Terminate these leads with 1/4” female connectors.
2.Connect the thermostat wires to the valve. (Fig. 48)
This completes assembly of the PDV20 and SDVR stove.
26 | 20003457 |