Radiance Natural Vent Gas Heater
Fuel Conversion Instructions
WARNING! This conversion kit shall be installed by a qualified service agency in accordance with the manufacturer’s instructions and all applicable codes and requirements of the authority having jurisdiction. If the information in these instruc- tions is not followed exactly, a fire, explosion or production of carbon monoxide may result causing property damage, personal injury or loss of life. The qualified service agency is respon- sible for the proper installation of this kit. The installation is not proper and complete until the operation of the converted appliance is checked as specified in the manufacturer’s instructions supplied with the kit.
CAUTION: The gas supply shall be shut off prior to disconnecting the electrical power, before proceeding with the conversion.
|
| OFF |
I |
| N |
H | O | |
| O | |
|
| PILOT ADJ |
|
| Main |
|
| Gas Line |
Gas Supply Inlet | ||
|
| ST226 |
Fig. 37 Attach the gas line to the left side of the valve. | ||
Conversion Precautions
This conversion must only be completed by qualified personnel. Before proceeding, turn control knob on valve to OFF and turn gas supply OFF. Turn OFF any electricity that may be going to the appliance. Caution: Allow stove to cool completely before begin- ning conversion.
Conversion Procedure
1.Remove stove front. Lift stove front up and then swing bottom out and away to disengage from the stove body. (Page 22, Fig. 44)
2.Undo the right and left latches at the top of the glass frame. (Page 22, Fig. 45)
3.Pull the top edge of the glass and frame assembly away from the firebox face. Place the assembly out of the way on a flat, padded surface such as a counter protected by a towel.
4.Remove the logset from the firebox.
5.Remove the rear log bracket by unfastening the screw and pulling the bracket away. (Fig. 38)
6.Remove the right and left log bracket assembly by unfastening the two screws which hold the burner in place. (Fig. 38)
Remove Screws | Rear Log Bracket |
Pilot
Left & Right Log |
|
Bracket Assembly | ST350 |
Fig. 38 Remove rear log bracket and left and right log bracket assembly.
7.Hold the burner at the right hand side and lift to clear the right burner leg. Then pull to the right to clear the injectors on the left hand side.
8.Remove injector orifices from left burner leg using 1/2” wrench. (Fig. 39)
9.Install conversion orifices. (Refer to Table 1)
10.Remove cap from HI/LO knob. This can be accom- plished by lifting the plastic cap off the screw. (Fig. 40)
11.Remove the screw from center of HI/LO knob with small screwdriver turning counterclockwise. (Fig. 40)
Left Burner Leg |
Injector Orifices |
90¡ |
ST353a
Fig. 39 Remove and replace injector orifices.
Cap
HI | Lift Open | HI |
| ||
LO |
| LO |
|
| |
Knob | Center Screw | CO100 |
|
|
Fig. 40 Remove center screw from HI/LO knob.
20004409 | 19 |
