Clearance Requirements
Minimum Clearances to
Combustible Materials
Measure side clearances as shown in Figures 2 through 5 from the outer edge of the cast iron stove top. Measure rear clearances from the rear sheet metal shroud.
The Radiance heater is approved for installation into an alcove constructed of combustible materials to the dimensions and clearances shown on this page.
The same clearances apply in a standard parallel installation.
Parallel Installation: Minimum Clearance
and Flue Centerline
C
L
C
D | A |
C
L
B
Stove Clearance | A: 4” (100mm) |
|
| B: 6” (150mm) |
|
Pipe Centerline | C: 21⁷⁄₈“ (556mm) |
|
| D: 8¹⁄₂” (216mm) | ST128b |
Fig. 2 Parallel installation, minimum back and side clear- ances, and flue centerlines.
Corner Installation: Minimum
Clearance and Flue Centerline
B
A
B
A
Stove Clearance: | A: 6” (150mm) |
Pipe Centerline: | B: 18” (460mm) |
ST129b
Fig. 3 Corner installation requirements.
Radiance Natural Vent Gas Heater
Ceiling Clearances
46"
(1168mm)
74"
(1880mm)
R A D I A N C E |
ST131b
Fig. 4 Minimum ceiling clearance: minimum alcove height.
Alcove Minimum Dimensions
42"
(1070mm)
4"
(100mm)
6" |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| 6" |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||
(150mm) |
|
|
|
|
|
|
|
|
|
|
|
| (150mm) | |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Fig. 5 The Radiance Natural Vent Stove is approved for installation into alcoves built of combustible materials.
Hearth Requirements
The Radiance Heater must be installed on rigid floor- ing. When the heater is installed directly on any combustible surface other than wood flooring, a metal or wood panel extending the full width and depth of the unit must be used as the hearth. There are no other hearth requirements.
WARNING:
• Always maintain required clearances (air spaces) to nearby combustibles to prevent fire hazard. Do not fill air spaces with insulation. All venting components must maintain a 1" (25mm) clearance to combustible materials. Maintain a 6” (150mm) clearance when using single wall pipe.
•The gas appliance and vent system must be vented directly to the outside of the building and never be attached to a chimney serving a separate solid fuel or
•Refer to the manufacturer's instructions included with the venting system for complete installation procedures.
20004409 | 5 |
