360DVS Series Direct Vent Fireplaces
Operating Instructions
Glass Information
Only glass approved by CFM Corporation should be used on this fireplace.
•The use of any
•Care must be taken to avoid breakage of the glass.
•Do not operate appliance with glass front removed, cracked or broken.
•Replacement glass (complete with gasket) is available through your Majestic Fireplaces dealer and should only be installed by a licensed qualified service person.
Louvre Removal
•The top side and top end louvres are removed by simply lifting the louvre assembly and pulling the as- sembly away from the fireplace. (Fig. 36)
•The lower side louvres are hinged along there lower edge and are folded down for access to components in the base cavity of the fireplace.
•The lower end louvre assembly on the 360DVS3/ SL/ SR units is removed in the same manner as the top louvre assemblies.
2.
Louvre
1.
Glass Panel
FP1227
Fig. 36 Remove louvre assembly top.
Window Frame Assembly Removal
Side Window Frame Assemblies
1.Shut off the gas supply.
2.Allow the fireplace to cool if it has been in operation.
3.Remove the top louvre assembly.
4.Lower the bottom louvre assembly.
5.Release the two clamps along lower edge of the frame by pulling down on clamp handles. (Fig. 37)
6.Tilt lower edge of frame out slightly and lift window frame assembly up and away from the fireplace.
7.To reinstall the window frame assembly reverse this procedure.
Front Window Frame Assembly
1.Remove the top and bottom louvre assembly.
2.Remove the lower window trim (held in place with magnets).
3.Remove both lower retaining screws. Access to these screws is gained through the holes along the lower edge of the frame behind the trim. (Fig. 38)
4.Tilt lower edge of frame out slightly and lift window frame assembly up and away from the fireplace.
5.To reinstall the window frame assembly reverse the process.
Lower Clamps | ||
| Window | |
Window | Frame | |
Assembly | ||
Frame |
| |
Assembly | Pull Clamp | |
Push | ||
Hook | ||
Clamp |
| |
Han-
FP1228
Fig. 37 Window frame assembly removal.
Location of Lower
Retaining Screws
FP1445
Fig. 38 Retaining screw.
10006326 | 23 |
