Vermont Casting D232 Glass Cleaning, Installation Of Logs & Burner Lava Rock Material

GLASS CLEANING

It will be necessary to clean the glass periodically. During start-up condensation, which is normal, forms on the inside of the glass and causes lint, dust and other airborne particles cling to the glass surface. Also initial paint curing may deposit a slight film on the glass. It is therefore recommended that the glass be cleaned two or three times with a non-ammonia household cleaner and warm water (we recommend gas fireplace glass cleaner). After that the glass should be cleaned two or three times during each heating season depending on the circumstances present.

Clean glass after first two weeks of operation.

INSTALLATION OF LOGS &

BURNER LAVA ROCK MATERIAL

D232

1 . Remove front glass. (See "Glass Removal" section)

2.Remove logs from packaging.

3.Place rear log (KR4) on rear bracket (ensure log is seated properly, leveled and centered to the unit), so it will not move from side to side and it is firmly positioned on the bracket.

4.Slip front ember log (KR1) down in the front deflector.

5.Place front left log (KR2) on top burner, left side. Use log's bottom holes to locate it into the left bracket log locator studs.

6.Place front right log (KR3) on top of burner, right side. Use log's bottom holes to locate it into the right bracket log locator studs.

7.Place small lava rocks and ember material on top of burner. (See Fig. 34 for proper location).

8.Place top left log (KR5) onto locator notches. Ensure log is secure.

9.Place top right log (KR6) onto locator notches. Ensure log is secure.

Top logs must be placed properly into notches

D232 KR5 KR6

KR4

KR2

KR3

KR1

Burner Lava Rock Placement

Fig. 34

- 19 -