Vermont Casting H33BDVRRN Wiring Instructions, EB-1Electrical Box, Ceramic Refractory Kits, Front

Pyromaster© H33BDVRRN/P

Wiring Instructions

The fireplace, when installed, must be electrically connected and grounded in accordance with local codes or, in the absence of local codes, with the current CSA C22.1 Canadian Electric Code.

For USA installations follow the local codes and the national electrical code ANSI/NFPA No. 70.

Should this fan require servicing or repair the power supply must be disconnected. For rewiring of any replacement parts refer to Figure 43.

Any electrical rewiring of this fan must be done by a licensed electrician.

Fan

Temperature

Sensor

Speed Control

Black

White

Ground

FP1025

Fig. 43 FK24 fan wiring.

EB-1 Electrical Box

The fireplace, when installed, must be electrically connected and grounded in accordance with local codes or, in the absence of local codes, with the current CSA C22.1 Canadian Electrical Code.

For USA installations follow local codes and the national electrical code ANSI/ NFPA No. 70.

3.Remove the plug socket assembly from the EB-1 box.

4.Feed the supply line in through the EB-1 opening in the side of the appliance and then through the back of the EB-1 assembly. (Fig. 44)

5.Connect the black wire of the power supply line to the brass screw (polarized) of the socket assembly.

6.Connect the white wire of the power line to the chrome screw of the socket assembly.

7.Connect the ground wire of the supply line to the green screw of the socket assembly.

8.Refit the socket assembly back into the electrical box and replace the cover plate. Secure the cable with the clamp on the outside of the EB-1 base plate and attach the EB-1 assembly to the unit with the screw removed in step 1.

	Inside		Electrical Box
	Retaining
	Screw
		Front
			of Unit
Outside
		of	Unit
		Front	CFM191a
Fig. 44	EB-1 receptacle.

It is strongly suggested that the wiring of the EB-1 Electrical Junction Box be carried out by a licensed electrician.

Ensure that the power to the supply line has been disconnected before com- mencing this procedure.

The EB-1 Electrical junction box option is available to allow for the easy connection of an optional fan kit.

To connect the EB-1 box to the house electrical supply follow the steps below.

1.Unscrew the retaining screw from the plate and remove from the appliance. (Fig. 44)

2.Remove the front cover of the EB-1 box.

Ceramic Refractory Kits

Ceramic Refractory Panel Kit #AT1CBB is available for this appliance.

Take care when handling the refractory panels as they are fragile until held in place and supported.

Installation, refer to Figures 45 & 46.

1.Remove the front window frame assembly.

2.Remove the logs.

3.Place the lower supports for the side refractory panels on the base of the firebox. Place each support so that the slotted hole fits over the forward screw head along the edge of the base.

10004798 29