LHEDV Series Direct Vent Insert
Operating Instructions
General Glass Information | LHECDV30 and LHERDV30 |
Only ceramic glass approved by CFM Cor- poration may be used for replacement on this unit.
1.The use of substitute glass will void all product warranties.
2.Care must be taken to avoid breakage of the glass.
3.Under no circumstances should this appliance be operated without glass properly installed, or with any cracked or broken glass. Replacement of any glass assembly as supplied by the manufacturer should be done by a licensed qualified service person.
Louvre Removal
To remove |
| |
louvre, lift louvre |
| |
up and then pull | 2. | |
out. | ||
| ||
(Fig. 20) | Louvre | |
| 1. | |
| Glass Panel | |
FP444 |
| |
Fig. 20 | Louvre removal. |
Glass Cleaning
It will be necessary to clean the glass periodically. During
Clean glass after first two weeks of opera- tion.
Glass Frame Removal
LHECDV20 and LHERDV20
1.Remove two (2) screws at the bottom of the frame. (Fig. 17)
2.Lift up and unhook glass frame at the top.
1.Unhook the frame window by pulling the handle of the two (2) latches at the bottom part of the window frame; pull the left side latch counterclockwise and the right side latch, clockwise. (Fig. 21)
2.Lift and unhook the glass frame at the top.
| Machine Screw |
|
| Latch | FP1328 |
Fig. 21 | Remove glass frame. |
|
Log Installation and Burner Lava Rock
1 . Remove glass frame. (See "Glass Removal" section)
2.Remove logs from packaging.
3.Place logs according to the model instructions be- low:
LHECDV20, LHERDV20 (Fig. 22)
a.Place rear left log (JR7). Use the log's bottom holes to locate it onto one pin stud of the rear log bracket on the left and the other end of the log will sit on top of the lid of the left log support.
b.Place rear right log (JR8). Use the log's bottom holes to locate it onto the two (2) pin studs of the rear log bracket on the right.
c.Place the front left log (JR9). Position the log notch against the second grate from the left, and the other edge of the log on top of the rear left log notch. Ensure the log is secure in place.
d.Place the front right log (JR10). Position the log notch against the third grate from the right, and the other edge of the log on top of the rear right log notch. Ensure the log is secure in place.
10004894 | 13 |