Vermont Casting SA24SHKRP Adding Pan Material, Grate Clip Installation, Connection To Gas Supply

Adding Pan Material

1.Open the bag of Vermiculite and spread it evenly across the Burner Pan, to the top, as shown in Figure 5. You may overflow the front and sides of the pan to cover the entire pan and connecting hardware.

2.Next, open the bag of Glowing Embers and place them on top of the Vermiculite, evenly across the Burner Pan. Be sure to separate the Glowing Embers into very small pieces before placing them.

	Glowing Embers
Figure 5	Vermiculite	LG216

Grate Clip Installation

1.Hook the U-Shaped part of the Grate Clips over the back horizontal bar of the Grate, as shown in Figure 6. Repeat with the other Clip.

2.Slide the rear edge of the burner pan into the three-pronged slot in the front edge of the grate clip, as shown in Figure 6.

Grate Clip
Back Bar Of Grate
Figure 6	LG217

Connection To Gas Supply

1.Center the burner pan from left to right in the fireplace and with the back of the grate against the back wall of the fireplace.

2.Attach the Gas Supply Fitting onto your fire- place’s gas supply pipe. Remember to use pipe thread sealant or teflon tape on this connection.

3.Attach one end of the Flexible Gas

4.Connector to the brass fitting on the back of the control valve, as shown in Figure 7.

5.Attach the other end of the Gas Connector to the flared side of the Gas Supply Fitting.

3311857

	Gas Supply Fitting
	Flexible Gas
	Connector
Figure 7	LG218
	7