Omega OMB-DAQBOARD-500 Install Software, Reference Notes, Installation, A Pictorial Overview

Reference Notes:

Each DaqBoard/500 Series plugs into a PCI bus-slot. Consult your PC owner’s manual as needed.

Reference Note: Adobe PDF versions of user manuals will automatically install onto your hard drive as a part of product support. The default location is in the Programs group, which can be accessed from the Windows Desktop. Refer to the PDF documentation for details regarding both hardware and software. Note that hardcopy versions of the manuals can be ordered from the factory.

Minimum System Requirements

•PC system with Pentium® 3 Processor

•500 MHz

•128 M-byte RAM

•Windows 2000 or XP Operating System

Installation, A Pictorial Overview

Step 1 – Install Software

IMPORTANT: Software must be installed before installing hardware.

1.Remove previous version Daq drivers, if present.

You can do this through Microsoft’s Add/Remove Programs feature.

2.Place the Data Acquisition CD into the CD-ROM drive. Wait for PC to auto-run the CD. This may take a few moments, depending on your PC. If the CD does not auto-run, use the Desktop’s Start/Run/Browse feature and run the Setup.exe file.

3.After the intro-screen appears, follow the screen prompts.

Upon completing the software installation, continue with step 2, Install Boards in available PCI Bus-slots.

IG-2 DaqBoard/500 Series Installation Guide 947994 1138-0940, rev 1.1