Section 2- Installation |
| Section 2- Installation |
SECTION 2
INSTALLATION
IMPORTANT:
It is highly recommended that your
merchandiser refrigerator be installed by an authorized Victory Certified Installer.
A. Receiving Shipment
Upon arrival, examine the exterior of the shipment packaging for any signs of rough handling.
If the cabinet is damaged, it should be noted on the delivery slip or bill of lading and signed to that effect. A claim must be filed immediately against the carrier indicating extent and estimated cost of damage incurred.
All units are performance tested and thoroughly inspected, prior to shipment. Upon leaving the factory, all units are in perfect condition and the carrier signs to this effect.
B. Uncrating Procedure
WARNING!!!!
DO NOT, Under Any Circumstances, Lay Your New Equipment Down on Either The Back, Front or Sides.
The shipping skid must be removed by tipping the model from side to side. Remove the leveler bolts while the model is held in one direction. Repeat this procedure when the model is held in the opposite direction.
ATTENTION!!!!
DO NOT THROW AWAY THE FOUR (4)
LEVELER BOLTS!
*Note:Once the uncrating process is complete, make sure the leveler bolts are safely and securely placed back on the bottom of the cabinet for proper support and leveling purposes.
CAUTION:
Exercise extreme caution when removing the wooden skid especially when the last bolt is removed, as the skid, if not properly blocked, will fall to the floor with extreme force.
C.R e d u c i n g M e r c h a n d i s e r D e p t h f o r Narrow Facility Doorway
In order to pass through a narrow doorway or restricted area the door, front grille and hinge brackets may be removed to reduce the overall depth of the cabinet to a minimum or 30" deep.
1. Removing Hinged Doors
a.Loosen the top hinge bracket screws while holding the top bracket down.
b. While holding the door against the cabinet, lift the top bracket until it clears the top hinge pin.
c.Lift the door until the bottom hinge pin clears the bottom hinge bracket.
d.Remove top and bottom hinge brackets and mount on the other side of the cabinet. Tighten bottom hinge bracket
screws. Leave top hinge bracket screws loose.
e. Insert bottom hinge pin into hole in bottom hinge bracket.
f.Lower top hinge bracket onto top hinge pin. Tighten the top hinge bracket.
D.Locating Your New Merchandiser
The following conditions should be considered when selecting a location for your merchandiser refrigerator.
1.Floor Load - The floor on which the cabinet will rest must be free of vibration and suitably strong enough to support the combined weights of the cabinet plus the maximum product load which might be
6