Section 2- Installation

 

Section 2- Installation

placed into it. To estimate the possible product load weight it is generally conceded that a safe figure is 35 pounds for each net cubic foot storage space. For example, a 47 cubic foot cabinet could hold approximately 1645 pounds of product (47 x 35 = 1645).

2.Ventilation - The air cooled, self-contained merchandiser refrigerator requires a sufficient amount of cool, clean air. Avoid placing the refrigerator near heat generating equipment such as ovens, ranges, heaters, fryers, steam kettles, etc., and out of direct sunlight. Avoid locating the self-contained refrigerator in an unheated room, or where the room temperature may be below 55°F.

E. Installation of Optional Legs or Casters

Merchandisers are shipped with leveler bolts that can be used to level the cabinet. However, legs and casters can be supplied that are of the 1/2" single stud mount type and requires no tools for installation. Simply remove the leveler bolts and then screw the casters or legs into the threaded holes located on the case bottom. To install low-profile rollers, remove carriage bolts from caster mounting plates and insert stem into bolt hole and tighten nut. Make sure that torque of caster bracket is inserted into 1/2” hole. This will prevent caster from turning.

Tilt the cabinet in one direction approximately eight inches and block it securely to keep it from falling. Use several pieces of 2 x 4 lumber or other suitable material. Screws the two left or right legs in snug. Repeat this procedure to install the other legs with the case bottom.

doors not sealing, closing properly or condensate water not draining properly.

G. Initial Cabinet Set-Up

Units are shipped with shelves. These items are secured to the rear of the cabinet directly on the wood skid.

1. Cleaning Cabinet

CAUTION:

DO NOT Use Abrasive Cleaning Solvents.

Never scour any part of your new cabinet. Scouring powders or chemicals may cause damage by scratching or dulling the surface finish. Prior to placing your new merchandiser refrigerator and all shelves into operation, it is advisable that the interior be washed thoroughly with a mild detergent and water solution. Rinse with clear water and a sanitizing solution. Allow cabinet to air dry.

For additional cleaning information, refer to the maintenance section of this service manual.

2. Installing Shelves

All merchandiser models include an interior which supports the adjustable and gravity organizing shelving.

Refer to pages 9 to 12 for detailed and illustrated shelf installation instructions for both standard shelving and beverage shelf kits.

WARNING

Never, Under Any Circumstances,

Lay Your New Merchandiser Refrigerator Down On Either It’s Back, Front or Sides.

F. Leveling

Cabinet must be leveled when installed. This is accomplished by rotating the leveler bolt. Failure to level your cabinet may result in

H. Electric Supply

The wiring should be done by a qualified electrician in accordance with local electrical codes. A separate ground wire must be supplied for all installations. A properly wired merchandiser refrigerator will assure proper operation. Please consult the "Data" plate attached to the compressor to assure the electrical requirements are correct. Supply voltage requirements are on the cabinet serial plate. It is recommended that a direct, properly fused line of the proper size wire be installed

7