Section 2- Installation |
| Section 2- Installation |
from the main supply to your merchandiser. It is most important that a voltage reading be made at the
All merchandiser refrigerator electrical systems are internally grounded. It is recommended that a bonding braid be secured to the base of the refrigerator and carried to a water pipe, to complete the ground.
I. Installation ChecklistAfter the cabinet has been installed, leveled and cleaned as described in the preceding paragraphs, refer to the following checklist prior to
NOTE: All motors are lifetime oiled and sealed. All
The serial data plate is mounted on the upper left interior wall.
NOTE: When ordering replacement parts, you must include the complete cabinet model and serial numbers.
•Full voltage of the correct type, on a line not affected by the operation of other electrical appliances, must be available for proper operation. Condensing units are designed to operate with a voltage fluctuation of plus or minus 10% of the voltage indicated on the cabinet electrical data plate.
•Leak check all exposed refrigeration lines. Make sure refrigeration lines are not dented, kinked or rubbing.
•Check condenser fan for freedom to rotate without striking any stationary members.
•Cabinet must be properly leveled.
•Do Not become alarmed if a trace of freon gas is detected in the internal cabinet air. This may be due to refrigerant used in expanding the foam insulation used in this cabinet.
8