Vidikron 60 » Control Panel on the Projector, Lamp Button, Temp Button, Power Button, Rgb Button

CONTROLS AND FEATURES

»Control Panel on the Projector

1. LAMP BUTTON:

Light On: Indicates the lamp has been used for more than 1900 hours.

Blinking: Indicates the lamp has been used for more than 2000 hours. Please change the lamp.

2. TEMP BUTTON

Blinking: Indicates the temperature inside the projector is abnormally high.

3.POWER BUTTON

Light On: During projection.

4.STANDBY BUTTON

Light On: In stand by mode.

Blinking: In cool down mode.

5.RGB BUTTON

Use this button to select a device connected to the [RGB1], [RGB2] or [RGB3] terminals.

6. VIDEO BUTTON

Use this button to select a device such as a video connected to the [VIDEO IN] terminal ([VIDEO] or [Y/C] Input terminal) of

the projector.

7. POWER BUTTON

When this projector is in standby mode, pressing this button for more than 1 second will turn the projector on and cause the [POWER] indicator to light up. Press it one second or more again, and the projector goes into the cool down mode and finally into stand by mode.

•The [POWER] button will not work within approximately 1 minute of the light-source lamp being turned on. Hence wait about 1 minute before pressing.

8. SVC BUTTON

This button is to be used by Vidikron Service Technician.

	1	2	3	4
					�������
	����		����
					�����
5	���		�����		7
					�����
6
				���	8
9
	����������	����������			10
11	����			����	12
			�����
13					14
15	���������		����		16

12. EXIT BUTTON

Press this button to display the previous menu (For example, from sub menu to main menu). Pressing this button when the main menu is displayed will erase the menu.

13. CURSOR BUTTON

These buttons are used in the menu mode to select an item, adjust the value etc.

14. ENTER BUTTON

Press this button to show the next menu (For example, from main menu to sub-menu). It is also used when [ENTER] is displayed against an item on the menu screen, or to choose the “Reset”

option etc.

9. V-KEYSTONE BUTTONS

Use this button to remove the vertical trapezoidal distortion of the image projected on the screen.

10. H-KEYSTONE BUTTONS

Use this button to remove the horizontal trapezoidal distortion of the image projected on the screen.

11. MENU BUTTON

Use this button to enter or exit the menu mode. When the main menu is displayed, pressing this button will cause the menu to

disappear.

15. KEY RESET BUTTON

This [RESET] button only works as a reset button for the [SVC], [V-KEYSTONE] and [H-KEYSTONE] adjustments done on the control panel and the [SVC], [V-KEYSTONE], and [H- KEYSTONE] adjustments done on the remote control. When adjusting the volume, keystone or digital zoom (when the setting is displayed on the screen) the adjusted value is reset to that which was set when the projector was shipped from the factory.

This button does not work for the menu (submenu) items.

16. MUTE BUTTON

Use this button to temporarily halt the audio and video output. Press again to resume.

10