OPERATION

POWER Indicator

STANDBY/ON Button STANDBY/ON

 

Button

ZOOM Knob

FOCUS Ring

Power Switch

Lens cap

Power ON

1Check to be sure the power cord is connected correctly.

2Set the power switch to [I]. When the standby mode is selected, the POWER indicator is orange.

3Press the STANDBY/ON button on the control panel or the remote control device. The warm-up starts and the POWER indicator blinks green.

4The POWER indicator stops blinking and turns green when the power is on.

5Remove the lens cap.

6Adjust picture size using the ZOOM Knob.

7Adjust focus with the FOCUS Ring.

Power OFF

1Press the STANDBY/ON button on the control panel or the remote control device. The message "Power off?" will appear on the screen. The message will disappear by any operation or if no operation is carried out for 5 seconds. During this message indication, press the STANDBY/ON button again. The projector lamp is turned off and the lamp will cool down. The POWER indica- tor blinks orange when the lamp cools down. Pressing the STANDBY/ON button has no effect while the POWER indicator is blinking.

2The system goes into the Standby mode after cooling, then the POWER indicator stops blinking and changes to orange. Check to be sure the indicator is orange then set the power switch to [0].

3The POWER indicator is extinguished when power is off. Be sure to replace the lens cap.

NOTE:

Except in emergencies, follow the above-mentioned procedure for turning the power off. Incor- rect procedure will shorten the life of the projector lamp and LCD panel.

To prevent any trouble, turn the projector on/off when the computer or video tape recorder is OFF. Providing a RS-232C cable is connected, turn on the computer before switching on the pro- jector.

ViewSonic PJ751

13

Page 16
Image 16
ViewSonic PJ751 manual Operation, Power on, Power OFF