Setting the User 1/User 2 mode
There are two
1.Press MENU/EXIT on the projector or MENU on the remote control to open the On- Screen Display (OSD) menu.
2.Go to the PICTURE > Color Mode menu.
3.Press 
/ 
to select User 1 or User 2.
4.Press 
to highlight Reference Mode.
This function is only available when User 1 or User 2 mode is selected up in the Color Mode
5.Press 
/ 
to select a picture mode that is closest to your need.
6.Press 
to select a 
/ 
. See
7.When all settings have been done, highlight Save Settings and press MODE/ENTER on the projector or Enter on the remote control to store the settings.
8.The confirmation message 'Setting Saved' is displayed.
Using Screen Color
In the situation where you are projecting onto a colored surface such as a painted wall which may not be white, the Screen Color feature can help correct the projected picture’s colors to prevent possible color difference between the source and projected pictures.
To use this function, go to the DISPLAY > Screen Color menu and press 
/ 
to select a color which is closest to the color of the projection surface. There are several precalibrated colors to choose from: Whiteboard, Greenboard, and Blackboard.
This function is only available when a PC type input signal is selected.
Fine-tuning the image quality in user modes
According to the detected signal type, there are some
Adjusting Brightness
Highlight the PICTURE > Brightness menu and press 
/ 
.
The higher the value, the brighter the image. And the lower the setting, the darker the image. Adjust this control so the black areas of the image appear just as black and that detail in the dark areas is visible.
Adjusting Contrast
Highlight the PICTURE > Contrast menu and press 
/ 
.
The higher the value, the greater the contrast. Use this to set the peak white level after you have previously adjusted the Brightness setting to suit your selected input and viewing environment.
+30 |
|
| +50 |
|
| +70 |
|
| 0 |
|
| +30 |
