Color Management
Only in permanent installations with controlled lighting levels such as boardrooms, lecture theaters, or home theaters, should color management be considered. Color management provides fine color control adjustment to allow for more accurate color reproduction, should you require it.
If you have purchased a test disc which contains various color test patterns and can be used to test the color presentation on monitors, TVs, projectors, etc., you can project any image from the disc on the screen and enter the Color Management menu to make adjustments.
To adjust the settings:
1.Go to the DISPLAY menu and highlight Color Management.
2.Press MODE/ENTER on the projector or Enter on the remote control and the Color Management page is displayed.
3.Highlight Primary Color and press 
/ 
to select a color from among Red, Yellow, Green, Cyan, Blue, or Magenta.
4.Press 
to highlight Hue and press 
/ 
to select its range. Increase in the range will include colors consisted of more proportions of its two adjacent colors.
Please refer to the illustration to the right for how the colors relate to each other.
For example, if you select Red and set its range at 0, only pure red in the projected picture will be selected. Increasing its range will include red close to yellow and red close to magenta.
5.Press 
to highlight Saturation and adjust its values to your preference by pressing 
/
. Every adjustment made will reflect to the image immediately.
RED Yellow GREEN
Magenta Cyan
BLUE
For example, if you select Red and set its value at 0, only the saturation of pure red will be affected.
Saturation is the amount of that color in a video picture. Lower settings produce less saturated colors; a setting of “0” removes that color from the image entirely. If the saturation is too high, that color will be overpowering and unrealistic.
6.Press 
to highlight Gain and adjust its values to your preference by pressing 
/ 
. The contrast level of the primary color you select will be affected. Every adjustment made will reflect to the image immediately.
7.Repeat steps 3 to 6 for other color adjustments.
8.Make sure you have made all of the desired adjustments.
9.Press MENU/EXIT on the projector or Exit on the remote control to exit and save the settings.
