ViewSonic PJL7211 manual Connecting power supply, Using the security bar and slot

Setting up

Connecting power supply

Put the connector of the power cord into the
1. AC IN (AC inlet) of the projector.
Firmly plug the power cord’s plug into the
2. outlet. In a couple of seconds after the
power supply connection, the POWER
indicator will light up in steady orange.
Please remember that when the DIRECT ON function
activated, the connection of the power supply make	AC IN	Power cord
the projector turn on.

WARNING ►Please use extra caution when connecting the power cord, as incorrect or faulty connections may result in fire and/or electrical shock.

•Only use the power cord that came with the projector. If it is damaged, consult your dealer to get a new one.

•Only plug the power cord into an outlet whose voltage is matched to the power cord. The power outlet should be close to the projector and easily accessible. Remove the power cord for complete separation.

•Never modify the power cord.

Using the security bar and slot

A commercial anti-theft chain or wire up to 10 mm in diameter can be attached to the security bar on the projector.

Also this product has the security slot for the Kensington lock.

For details, see the manual of the security tool.

Anti-theft chain or wire

Security slot

Security bar

WARNING ►Do not use the security bar and slot to prevent the projector from falling down, since it is not designed for it.

CAUTION ►Do not place anti-theft chain or wire near the exhaust vents. It may become too hot.

NOTE • The security bar and slot is not comprehensive theft prevention measures. It is intended to be used as supplemental theft prevention measure.

ViewSonic 11 PJL7211