ViewSonic VS13835 warranty Shutting the projector down, Resetting all settings

Troubleshooting

Regarding the indicator lamps (continued)

POWER	LAMP	TEMP	Description
indicator	indicator	indicator
			There is a possibility that the interior portion
			has become heated.
			Please turn the power off, and allow the projector to cool down at least
Blinking			20 minutes. After the projector has sufficiently cooled down, please make
			confirmation of the following items, and then turn the power on again.
In Red	Turned	Lighting
			• Is there blockage of the air passage aperture?
or
	off	In Red	• Is the air filter dirty?
Lighting
			• Does the peripheral temperature exceed 35°C?
In Red
			• Is the setting for FAN SPEED appropriate?
			For details on FAN SPEED, refer to FAN SPEED of SERVICE in the
			OPTION menu. If the projector is used with a wrong setting, it may
			cause damage to the projector itself or the parts inside.
			It is time to clean the air filter.
Lighting	Simultaneous		Please immediately turn the power off, and clean or change the
			air filter referring to the section Cleaning and replacing the air
In Green	blinking in Red
			filter. After cleaning or changing the air filter, please be sure to
			reset the filter timer. After the remedy, reset the power to ON.
			There is a possibility that the interior portion
Lighting	Alternative		has become overcooled.
			Please use the unit within the usage temperature
In Green	blinking in Red
			parameters (5°C to 35°C).
			After the treatment, reset the power to ON.
Blinking In			At least 1 Power ON schedule is saved to the
Green for	Turned	Turned	projector.
approx. 3	off	off	Please refer to 3.7 Schedule Settings in the Network
seconds.			Guide.

NOTE • When the interior portion has become overheated, for safety purposes, the projector is automatically shut down, and the indicator lamps may also be turned off. In such a case, disconnect the power cord, and wait at least 45 minutes. After the projector has sufficiently cooled down, please make confirmation of the attachment state of the lamp and lamp cover, and then turn the power on again.

Shutting the projector down Shutdown switch

Only when the projector can not be turned off by usual procedure, please push the shutdown switch using a pin or similar, and disconnect the power plug from the power outlet. Before turning it on again, wait at least 10 minutes to make the projector cool down enough.

Resetting all settings

When it is hard to correct some wrong settings, the FACTORY RESET function of SERVICE item in OPTION menu can reset all settings (except settings such as LANGUAGE, LAMP TIME, FILTER TIME, FILTER MESSAGE, SECURITY and NETWORK) to the factory default.

ViewSonic 101 Pro9500