GATE OPERATOR INSTALLATION

CAUTION - If mounting bar is not welded to a frame member that runs the full length of the gate, the gate operator may damage the gate. Do not weld the bar or backing plate to a few pickets.

STEP 1

Check the integrity of the gate structure and sufficiently sturdy such as pivot points are properly lubricated and surfaces are free of rust.

a)Remove the Motor/Gear Assembly from its package. NOTE - The cover is not secured.

b)Disassemble the geared motor from the mounting chassis.

STEP 2

Position the pivot bracket in accordance with figure A, B or C on page 10 or 11 and the drawing at the right.

Tack weld the bracket in place. For non-ferrous gates the bracket can be bolted in place.

STEP 3

Chassis Installation:

Chassis can be welded to the gatepost. In the case of a non-ferrous post, anchoring the chassis may require an additional embedded bracket or special anchoring hardware to ensure the longevity of the installation.

Note: Depending on type of anchor used, it may be required to enlarge the holes in the mounting chassis.

14.173"

5.90" 5.90" 1.181"

3.937"

Motor/Gear Chassis

1-1/2"

12

TECHNICAL SUPPORT 1 800 908 0884