Viking Access Systems UL 325, UL 991, X-9 Opening/Closing Setup:, Reference Wiring Diagram, Limit Switch Connections

GATE OPERATOR INSTALLATION

Opening/Closing Setup:

To have the gate operator slow down prior to reaching its limits use the following steps:

1.Setup the limit switches manually at the desired open and close position.

2.Allow the gate operator to run a full open and close cycle (from limit to limit) without interruption.

Note: During the first full open and close cycle: The gate operator doesn’t slow

down prior to reaching its limits. During subsequent cycles: The gate operator will slow down prior to reaching its limits.

3. Verify that the gate opens and closes to the desired position.

To change the open or close limit position(s) the following steps MUST BE taken:

A. Reset the gate operator by performing one of the following steps:		Slow
i. Disconnect the Power Harness Connector (see page 17) or Fast
ii. Disconnect the Motor/Limit Harness Connector
(see page 18 or 19) or
iii.Actuate both limits at the same time	Slow

B. Repeat steps 1,2 and 3.

Reference Wiring Diagram

Connect the lead wires as shown

											Wire Lead
To Limit										From Control Box
Switches											To Motor
		g								Bl
	n		e							u	e
ra					w
O				l				n	Bl
				lo					a	ck
			e				w
			Y
							ro
						B		d
								e
							R

Limit Switch Connections

The Limit Switches are wired as shown

Note: Use this wiring diagram as a guide to connect the wires to the motor unit.

O						M
C					O
M	N		C	C
	C	N
	N			N0
	0

Yellow Brown Orange Red

TECHNICAL SUPPORT 1 800 908 0884 15