TROUBLESHOOTING
Gate opens after few second delay
Set the overlap delay trim pot to 0. Refer to page 28.
Note: Overlap trim pot is normally recommended to use in overlapping gates. Refer to page 28.
Gate opens. Closes or stops on its own
Check that your external | Check that your wires from |
devices are working properly | your accessories are: |
| a) Not shorting together |
| b) Not shorting a power line |
| c) Not shorting to metal or |
| earth ground. |
Set the overlap delay trim pot to 0. Refer to page 28.
Note: Overlap trim pot is normally recommended to use in overlapping gates. Refer to page 28.
‘Charger’ LED off. Gate does not run - alarm sounds upon any input command
Check the 4 Amp fuse on the | Check the 3 Amp fuse on the | Make sure the incoming AC |
control board. | EMI control board. Refer to | line is properly connected. |
| page 17. | Refer to page 17. |
|
|
|
Check the incoming high | Check the proper selection of | Verify the EMI board by |
voltage power supply. | power supply (120/220 VAC). | reading high voltage across the |
| Refer to page 17. | (4) blue and red wires at the |
|
| terminal block connections. |
Battery voltage reads zero or very low
Ensure the batteries are connected as follows:
a)Left battery - Black terminal connected to the black wire from the harness (jacketed wire)
b)Left battery - Red terminal connected to the red wire from fuse holder
c)Right battery - Black terminal connected to the red wire from fuse holder
d)Right battery - Red terminal connected to the red wire from the harness (jacketed wire)
TECHNICAL SUPPORT 1 800 908 0884 | 33 |