Vita-Mix XTG012 owner manual Instructions, The speed of the motor can be changed with

Instructions

CONTINUED FROM PAGE 15

1.Follow steps 1 through 3 of “How to operate your Blending Station® MP using the Six Pre-Set Programmed Buttons” section on page 14.

2.The speed of the motor can be changed with:

• the motor off.	• the motor on.
– Press the ▲ or ▼ buttons	– With the container in place, press the
until the desired speed	START/STOP button. The machine
percentage is displayed.	will begin blending.
100% is the highest setting	– While the machine is running, press
and 7% is the lowest setting.	the ▲ or ▼ buttons
– When the START/STOP button is	until the desired speed
pressed, the motor will ramp	percentage is displayed.
quickly to that speed.	100% is the highest setting
– Blending can be stopped by	and 7% is the lowest setting.
pressing the START/STOP	– Release the SPEED CONTROL
button at any time.	button and the motor will now run at
	the desired speed.
	– The blending can be stopped by
	pressing the START/STOP button.

3.The PULSE button can also be used to quickly increase the motor speed or decrease the motor speed. (See HIGH/LOW PULSE button description on page 5.)

4.When done blending, press the START/STOP button to stop the motor.

Wait until blade comes to a complete stop before removing the lid and/or container from the motor base.

5.Remove the container from the motor base and serve the drink.

NOTE: On all units, the built-in thermal sensor keeps track of how hot the motor gets and will warn the user and eventually shut down the motor if the motor is overheating. When overheated, the display will instruct the user to remove the container and run the machine until cool. This takes about two minutes. See page 25, “Cooling the motor,” for complete instructions. When overheating occurs, review your techniques and instructions. The motor may be getting hot when your recipes are too thick. Consider adding more liquid and consult Vita-Mix®or your local Vita-Mix Distributor for further assistance.

16