7. Problem: | Solution #1: |
• Machine is running irregular | Turn the machine OFF and ON again to reset |
• Display panel reads garbage | the programming. |
• “NO PROGRAM” is displayed when a | Solution #2 |
button is pushed | Reset the machine to its original factory |
• Button pressed starts the wrong | settings. (Follow the instructions on page 7.) |
program | Solution #3: |
• Machine starts by itself | Try plugging the machine into a new outlet. |
• A specific program button is defective | Solution #4: |
• Machine was turned off for a day, | Call |
week or month and turned on, but |
|
there is no power |
|
• Machine did not work right out of |
|
the box |
|
• Machine works but no information |
|
displayed on screen |
|
• Program buttons run the blender on |
|
the same speed |
|
|
|
8. Problem: | Solution #1: |
• Display panel reads | A new programming chip is needed. Call |
CORRUPT DATA | |
| |
|
|
9. Problem: | Solution #1: |
• Machine stops in the middle of its | Plug the machine into its own power supply. |
blend cycle and resets; display panel | Solution #2: |
reads | Make sure the machine is not running on a |
PROGRAM” then “READY” | long extension cord. |
|
|
Cooling the motor:
If the machine has overheated:
MOTOR HAS OVERHEATED REMOVE..
HOT SHUTDOWN
READY
•The motor will stop and the message “MOTOR HAS OVERHEATED REMOVE THE CONTAINER, THEN PRESS START,” will scroll across the display window, while the words “HOT SHUTDOWN” will remain in the display window alerting you of the problem.
•The machine will not run until the container is removed and the motor has cooled. Remove the container, shut the cover door and press the START/STOP button and run the machine for two minutes.
•When the motor is cool, “READY” will appear in the display window.
If you cannot fix your machine with these suggestions, technical help is available by calling
25
