VIVOTEK - A Leading Provider of Multimedia Communication Solutions
Ceiling mount without the bottom base (Embedded)
1.Attach the supplied ceiling hole template sticker to the ceiling.
2.Open a hole along the inner circle of the sticker.
3.Using the 3 circles on the sticker, drill 3 pilot holes into the ceiling. Then hammer the three supplied plastic anchors into the holes.
4.Mount the Network Camera to the ceiling and feed the cables through.
5.Using the three holes on the side of the camera base, insert the three supplied screws into the corresponding holes and secure them with a screwdriver.
5
4
1 | 2 | 3 |
|
|
Drill hole
Ceiling Hole Template Sticker
Network Deployment
Setup the Network Camera over the Internet
This section explains how to configure the Network Camera to an Internet connection.
1.If you have external devices such as sensors and alarms, make the connection from the general I/O terminal block.
2.Use the supplied RJ45 female/female coupler to connect the Network Camera to a switch.
Use a Category 5 Cross Cable when Network Camera is directly connected to PC.
3.Connect the power cable from the Network Camera to a power outlet.
1
N.C. 
N.C. 
N.C. 
AC24V 
AC24V 
GND 
DI 
DO 
+12V 
N.C.: No Connector
N.C.: No Connector
N.C.: No Connector
AC24V: Power in AC 24V
AC24V: Power in AC 24V
GND: Ground
D I : Digital Input
D O : Digital Output
+12V : Power, 12V DC
N.C. N.C. N.C.
AC24V AC24V
2
3
10 - User's Manual
