Vivotek FD8131 user manual Continuous recording

VIVOTEK

If you enable adaptive recording and enable time-shift cache stream on Camera A, only when an event is triggered on Camera A will the server record the full frame rate streaming data; otherwise, it will only request the I frame data during normal monitoring, thus effectively save lots of bandwidths and storage space.

NOTE NOTE:

Bandwidth
I frame ---> Full frame rate --->	I frame
Bandwidth
Activity Adaptive Streaming
for Dynamic Frame Rate Control
Continuous recording	Time

►To enable adaptive recording, please make sure you’ve set up the trigger source such as Motion Detection, DI Device, or Manual Trigger.

►When there is no alarm trigger:

-JPEG mode: record 1 frame per second.

-H.264 mode: record I frame only.

-MPEG-4 mode: record the I frame only.

►When the I frame period is >1s on Video settings page, firmware will force decrease the I frame period to 1s when adaptive recording is enabled.

The alarm trigger includes: motion detection and DI detection. Please refer to Event Settings on page 82.

■ Pre-event recording and post-event recording

The Network Camera has a buffer; it temporarily holds data up to a certain limit. Enter a number to decide the duration of recording before and after a trigger is activated.

■Priority: Select the relative importance of this recording (High, Normal, or Low). Recording with a higher priority setting will be executed first.

■Source: Select a stream as the recording source.

NOTE NOTE:

► To enable recording notification please configure Event settings first . Please refer to page 82.

Please follow the steps below to set up a recording setting.

1. Trigger

Select a trigger source.

■Schedule: The server will start to record files on the local storage or network storage (NAS).

■Network fail: In the event of a network failure, the server will start to record media files on the local storage (SD card).

100 - User's Manual