VIVOTEK
6 - User's Manual
Physical Description

General I/O Terminal Block

This Network Camera provides a general I/O terminal block which is used to connect external
input / output devices. The pin deî‚¿nitions are described below. The 24V AC can be used as an
alternate power source.

Hardware Reset

The reset button is used to reset the system or restore the factory default settings. Sometimes
resetting the system can return the camera to normal operation. If the system problems remain
after reset, restore the factory settings and install again.
Reset: Press and release the recessed reset button with a straightened paper clip. Wait for the
Network Camera to reboot.
Restore: Press and hold the recessed reset button until the status LED rapidly blinks. Note that
all settings will be restored to factory default. Upon successful restore, the status LED will blink
green and red during normal operation.

Micro SD/SDHC Card Capacity

This network camera is compliant with Micro SD/SDHC 16GB / 8GB and other preceding
standard SD cards.
Lens
Reset Button
General I/O Terminal Block
Status LED
MicroSD/SDHC
Card Slot
Black Cover
Ethernet 10/100 RJ45 Plug
Power Cord Socket
Ground wire
Pin Name
+ Digital Input +
- Digital Input -