VIVOTEK
Hardware Installation - FE8181V
Please refer to page 20 for the installation details of the FE8181.
Opening Dome Cover
First, use the supplied screwdriver to loosen the four screws and detach the dome cover from the camera base. Then, follow the steps below to install the camera to either a ceiling or a wall.
Remove the stoppers and route cables through the openings.
Rubber Stopper on the hole for Power & IO Cables
Rubber Seal Plug on the hole for RJ45 Ethernet Cable
WARNING:
Due to its high performance IR lights, the surface temperature of the dome cover can reach
70ºC after operating in the night mode for a period of time. You should then wait for the surface
to cool down if you should need to
User's Manual - 13
