Modem Environment

Hardware installation

Before installing Network Camera, the administrator should memorize the serial numbers on the packages respectively for the initial passwords.

To use a dial-up network, the Ethernet socket should be left disconnected since Ethernet is the first priority among available interfaces. After powering up, Network Camera will detect if any external modem is connected to the modem port. Once a modem is detected, the heartbeat LED will flash periodically. If no modem responds, Network Camera will assume the included null modem cable is connected to perform system configuration. Then both lower LEDs will turn on until null modem connection is established.

If users have setup a remote dialup server or subscribed to an ISP service, Network Camera can be configured to dial to the server upon special events. Otherwise it will wait permanently for the user’s call to establish a network connection to provide services.

In the following content, dial-in connection denotes a passive Network Camera waiting for a phone call to establish a point-to-point connection. Dial-out connection denotes an active Network Camera to dial out to the other end of a dial-up server or any Internet service provider, abbreviated as ISP, to request a point-to-point connection.

23

www.vivotek.com

T: 886-2-22404099

F: 886-2-22404097

Page 24
Image 24
Vivotek IP3111/3121 manual Modem Environment, Hardware installation