Vivotek VS8100 user manual Preset positions, Position is set as the center position

VIVOTEK

Preset positions

If you select DynaDome/SmartDOME, Lilin PIH-7x00, or Pelco D, Pelco P protocol, Samsung scc643 protocol protocol as the PTZ driver and click the Save button, the Preset Position button will be enabled. Click Preset Position to open the settings page. You can also select preset positions for the camera to patrol. A total of 20 preset positions can be configured.

Please follow the steps below to preset a position:

1.Select Channel in the drop-down list.

2.Adjust the shooting area to the desired position by using the buttons on the right. The default Home

position is set as the center position.

3.Enter a name for the preset position, which allows up to forty characters. Click Add to enable the settings. The preset positions will be displayed under User preset locations.

4.To add additional preset positions, please repeat steps 1~2.

5.Select the preset positions and click on Save to enable the settings.

6.The positions saved will show up in Go to drop down list on the Home page. See next page

7. To remove a preset position from the list, select it and click Remove. Functions are the same

1

as the Control Panel on

2the home page

6

3

7

5

76 - User's Manual