VTech 917ADX manual Speakerphone Spkr KEY, Volume UP KEY, Volume Down KEY, Making Calls, Tonekey

Models: 917ADX

1 19
Download 19 pages 37.01 Kb
Page 10
Image 10

O P E R A T I N G INST43,U.,C;J!QNS, d i , - 6 li

RkDIAL KEY':ti,> -..\r

When you hear a dial tone, press this key to redial the last phone number you dialed on your 917ADX.

INTERCOM (INT.COM) KEY ,

Press this key to initiate two-way, inter- nal communicationbetweenthe Base Unit and Handset.

If the Handset is in the OFF mode, it will ring a maximum of 4 times. The Hand- set user can respond to the INTERCOM ring by pressing INT.COM. The Handset user can also choose to ignore the IN- TERCOM ring, in which case, the ringing will stop after 4 rings. Otherwise, the Handset user can press OFF, which will terminate the ringing.

Press INT.COM to terminate INTERCOM mode.

SPEAKERPHONE (SPKR) KEY

Press this key to use the SPEAKER-

.PHONEfor making or answering calls. Press SPKR to end the call.

VOLUME UP KEY

Press this key to increase the Base Unit speaker volume. A series of rapid beeps tell you that maximum volume level has been reached.

The volume level will continue to incre- ment up if this key is held down. There are a total of 8 volume settings.

VOLUME DOWN KEY

IMPORTANT: Whenever the Handset battery

 

Press this key to decrease the Base Unit

pack is removedand then replaced, the Hand-

set must be reinitializedon the Base Unitcradle.

speaker volume. A series of rapid beeps

The Charge (CHR) LED on the Base Unit will

tell you that minimum volume level has

flash during the initialization.

 

 

been reached.

 

,

 

 

 

The volume level will continue to

'

 

 

increment down if this key is held down.

 

 

 

 

 

There are a total of 8 volume settings.

MAKING CALLS

,

-

 

 

 

 

From the Handset

 

 

'TONEKEY

Pick up the Handset and press PHONE.

When you hear a dial tone, dial the number.

rn From the PULSE (Rotary) dialing mode,

The IN USE LED (on the Base Unit) and

press this key to switch to TEMPORARY

PHONE LED (on the Handset) will light.

TONE dialing mode.

 

 

 

When the call is ended, the phone will return to PULSE dialing mode.

If you make a mistake when dialing, press OFF to hang up, then press PHONEto get a dial tone again.

You must always press PHONE before you can dial a call on the Handset.

Disconnecting

To end a call, either place the Handset back in the Base Unit, or press OFF on the Handset.

From the Speakerphone

The Base Unit also works as a Speaker- phone. It allows you to make and receive calls without using the Handset. You can use the Speakerphone while the Handset is in or out of the base.

Press SPKR on the Base Unit. You will hear the dial tone over the speaker. Use the Volume Control keys to adjust the speaker to a comfortable listening level. Dial the number on the keypad of the Base Unit. When the party answers, speak toward the microphone, located at the lower front edge of the Base Unit.

To hang up, press SPKR again on the Base Unit.

MAKING 6 REClEVlNG

CALLS WllHOUTUSING

7,-Ds=

Page 10
Image 10
VTech 917ADX manual Speakerphone Spkr KEY, Volume UP KEY, Volume Down KEY, Making Calls, Tonekey