This equipment complies with Parts 15 and 68 of the Federal CommunicationsCommission (FCC) rules for the United States.

installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interferencewill not occur in a particular installation. If this equipment does cause harmful interferenceto radio or television reception, which can be determined by turning the equipment off and on, the user is encouragedto try and correct the interferenceby one or more of the following measures:

4 A label is located on the underside of the Base Unit containing either the FCC registration number and Ringer EquivalenceNumber (REN). You must, upon requsst, provide this informa- tion to your localtelephone company.

-

-

-

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet or on a circuit different from that to which the receiver is connected.

I!

I

This equipment is compatible with inductively coupled hearing aids.

 

- Consult the dealer or an experienced radioflV technician for help.

 

 

Should you experience trouble with this telephone equipment, please contact:

 

FCC Part 68

 

 

 

 

The FCC requires that you connect your cordless telephone to the nationwide telephone net-

 

 

work through a modular telephone jack (USOC RJ1lC or RJllW).

 

 

Your telephone company may discontinue your service if your equipment causes harm to the

 

 

telephone network. They will notify you in advance of disconnection,if possible. During notifi-

 

 

cation, you will be informed of your right to file a complaint with the FCC.

 

I

Occasionally, your telephone company may make changes in its facilities, equipment, opera-

.

 

tion, or procedures that could affect the operation of your equipment. If so, you will be given ad-,

 

, ,

 

vance notice of the change to give you an opportunity to maintain uninterruptedservice.

-

 

for repairlwarranty information. The telephone company may ask you to disconnect this

 

equipment from the line network until the problem has been corrected.

The Base Unit contains no user serviceable parts. The Handset contains a user replaceable

battery pack.

 

Your 917ADXis designed to operate at the maximum power allowed by the FCC. This

If it is determined that your telephone equipment is malfunctioning,the FCC requiresthat it

means your Handset and Base Unit can communicateonly over a certain distance which will

not be used and that it be unplugged from the modular jack until the problem has been cor-

depend on the location of the Base Unit and Handset, weather, and the construction and layout

rected. Repairs to this telephone equipment can only be made by the manufacturer or its au-

of your home or office.

thorized agents or by others who may be authorizedby the FCC. For repair procedures, follow

 

 

the instructions outlined under the VTECH Limited Warranty.

I

I

I

,

FCC Part 15

Warning: .Changes or modificationsto this unit not expressly approved by the party responsible for compliancescould void the user's authorityto operate the equipment.

The equipment has been tested and found to comply with part 15 of the FCC rules. These limits are designed to provide reasonableprotection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not

This equipment may not be used on coin service provided by the phone company or Party Lines.

The REN is useful in determiningthe number of devices you may connect to your telephone line and still enable the devices to ring when you receive a call. The general rule is that the REN value should not exceed 5.0 total; however, contact your local telephone company for the specific number in your area.

Page 18
Image 18
VTech 917ADX manual FCC Part