VTech 917ADX Frequencycontrol, Transmit Frequency, Receive Frequency, Nominal Effective Range

F C C & I C R E G U L A T I O N S

IC (Industry Canada)

This telephone is registeredfor use in Canada.

Notice: The lndustry Canada label indentifies certified equipment. This certification means that the equipment meets certain telecommunicationsnetwork, protective , operational and safety requirements. lndustry Canada does not buaranteethe equipment will operate to the user's

satisfaction. . 1 \ % . *

Before installing this equipment, users should ensure to the facilities of the local telecommu- nications company. The equipment must also be installed using an acceptable method of connections. The customer should be aware that compliance with the above conditions may not prevent degradation of serviec in some situations.

Repairs to certifiedequipment should be made by an authorized Canadian maintenance facility designated by the supplier. Any repairs or alterations made by the user to this equipment, or equipment malfunctions, may give the telecommunicationscompany cause to request the user to disconnect the equipment.

Users should ensure for their own protection that the electrical ground connectionsof the power utility, telephone lines and internal metallic water pipe system, if present, are connected together. This precaution may be particularly important in rural areas.

Caution :Users should n,ot attempt to make such connectionsthemselves, but should contact

.'>z', 2% -

amro~riateelectric ins~ectionauthoritv. or electrician. as amro~riate.

The Load Number (LN) assigned to this device denotes the percentage of the total load to be connected to a telephone ollp which is used by the device to prevent overloading. The termina- tion on a loop may consist of any combination of devices subject only to the requirement that the total of the load numbers of all devices does not exceed 100.

This device complies with RSS-210 of lndustry Canada. Operation is subject to the following two conditions:(l) this device may not cause interference,and (2) this device must accept any interference, including interference that may cause undesired operation of the device.

T E C H N I C A L S P E C I F I C A T I O N S

FREQUENCYCONTROL

Crystal Controlled Dual PLL Synthesizer

TRANSMIT FREQUENCY

Handset:	925.05 MHz to 927.75 MHz (All ten channels within this range)
Base:	902.3 MHz to 905.0 MHz (All ten channels within this range)
RECEIVE FREQUENCY
Handset:	902.3 MHz to 905.0 MHz (All ten channels within this range)
Base:	925.05 MHz to 927.75 MHz (All ten channels within this range)

NOMINAL EFFECTIVE RANGE

Maximum power allowed by FCC & IC. Actual operating range may vary according to environ- mental conditions at the time of use.

SIZE45fh
Handset:	18.2cm x 6.2cm x 3.8cm
	(L x W x T) maximum
	(antennaexcluded)
Base:	21.0cm x 14.8cm x 5.5cm
	(L x W x T) maximum
	(antenna excluded)
WEIGHT
Handset:	250 grams
Base:	550 grams
POWER REQUIREMENTS
Handset:	Self-containednickel-cadmiumrechargeable battery supply, 3.6V nominal,
	6OOmAh capacity.
Power Adaptor:	9V DCQ500mA

SPECIFICATIONSARE TYPICAL AND MAY CHANGE WITHOUT NOTICE.