W A L L M O U N T I N G
The Wall Mount adaptor is designed to fit on standard Wall Mount plates.
C h o o s e a s p o t n e a r a n e l e c t r i c a l o u t l e t a n d a telephone jack.Your phone requiresa modular telephonejack and a standard electrical outlet(l20v AC). The power cord is six feet long; make sure there is an electrical outlet within reach of the base.The outlet should not be controlled by a wall switch. If the switch is ever turned off, the phone will not operate.
I I WHEN | I |
WALL MOUNTING |
|
ANDTELEPHONE JACK |
|
Position the wall mount adaptor on the base. Line up the tabs on the wall mount adaptor with the holes on the bottom of the base. Snap the wall mount adaptor firmly in place.
Mount the base on the wall. Positionthe base so the mounting studs will fit into the holes on the bottom of the base.Position the power cord to extend down the wall the phone is to be mounted on. Slide the base down on the mounting studs until it locks into place.
INSERT WALL MOUNT
INTO THE BASE UNIT
Connect the telephone cord. The telephone line cord has a
Plug the AC adaptor into an electrical outlet, and the DC connector on the back of the Base Unit.
JACK
IMPORTANT:
When wall mouting your 917ADX, you must reverse the handset hook, located in the charging cradle.
Otherwise your handset may fall
Ifrom the Base Unit when cradled.
