•If you have caller ID service, the clock will be set automatically with incoming calls, but you will need to make sure the year is correct. See Set the clock for instructions on how to set the year, time and day manually.
•Press and hold 
/SKIP or
/REPEAT while setting the minutes or year to advance or decrease by increments of 10.
Answering system
Set the clock
Prior to playing a message, the answering system announces when it was received. Before using the answering system, set the year, time and day, so that messages are dated correctly. If the clock is not set before new messages are recorded, the system will announce “Time and day not set,” before each message is played to remind you to set the clock.
1.Press CLOCK. The system announces the clock setting (e.g. year, time and day), then announces: “To set the clock, press CLOCK.”
2.Press CLOCK. The system announces the current year.
3.Press 
/SKIP or 
/REPEAT until the system announces the correct year, then press CLOCK. The system announces the current hour.
4.Press 
/SKIP or 
/REPEAT until the system announces the correct hour, then press CLOCK. The system announces the current minute.
5.Press 
/SKIP or 
/REPEAT until the system announces the correct minute, then press CLOCK. The system announces the current day.
6.Press 
/SKIP or 
/REPEAT until the system announces the correct day, then press CLOCK. After a confirmation tone, the system announces the new clock setting and exits programming mode.
38 | www.vtechphones.com |
